Radio remote controll FFS
The new radio remote control from Cleantecs GmbH is the result of twenty years of experience in the production of ELCA Srl security radio remote controls, in conjunction with special adaptations and improvements specifically designed to meet the requirements of PV cleaning service providers. Maximum operational safety, reliability and shock resistance render this radio remote control indispensable. The complete set consists of a transmitter, receiver and charging adapter. The range of the radio remote control can be greatly extended with an optionally available antenna. At the push of a button, the rotating brush can be stopped. This is achieved by simply interrupting the power supply to your high-pressure cleaner. The brush is restarted the same way and just as easily. The radio remote control can be ergonomically carried on person.
Radio remote control FFS230
| Voltage | 230 Volt |
| Range with obstacle | approx 150 m |
| Range without obstacle | approx 380 m |
| Item number |
0200936 |
Radio remote control FFS400
| Voltage | 400 Volt |
| Range with obstacle | approx 150 m |
| Range without obstacle | approx 380 m |
| Item number |
0200937 |
Antenna PLUS AP530
| Increase the range | approx 150 m |
| Length | 2,2 m |
| Item number |
0201368 |
PLUS 150 m more range!
This high-quality antenna allows you to increase the range of the system.
Submit an enquiry
Would you like to get some advice?
Give up a call!
Tel. +49730792650
To submit an enquiry, please use our form.
The new models
Security redefined!
The radio remote control system consists of two main units:
- the transmitter unit (AT) and the receiver unit (AR).
Each radio remote control uses a unique identification code that is configured by the manufacturer and cannot be subsequently changed. This means that each transmitter can only operate specifically associated receivers and cannot cause interference with other radio remote control systems. One or more transmitters can be associated with particular receivers via an identification code "learning" procedure. The best working frequency with the least interference is automatically selected from the available frequencies when the transmitter is activated. Radio interference occurring during the operational phase causes an automatic change of the working frequency without interrupting the activity currently being performed by the operator.
In addition to allowing selection of the working frequency with the least interference, the special Full Duplex LBT (Listen Before Transmit) communication system also allows management of the information coming from the receiver, since the transmitter and receiver communicate in both directions. This exchange of information between the transmitter and receiver provides the user with full monitoring of the machine being controlled, because the receiver always confirms the receipt and activation of every transmitted command by replying with a "reception confirmation signal". lt the transmitter does not receive this "reception confirmation signal" then it cancels the transmission and notifies the user that the command cannot be reliably sent.
The highly advanced, state-of-the-art signal coding and decoding protocol used by this unit guarantees a high level of security.
Downloads
 |
| Original - User manual (pdf) |
 |
| Brochure (pdf) |
+49730792650